Aftermarket Bar Mounts?

Commenti

3 commenti

  • Avatar
    Thierry CHARLÈS

    Hello,

    Take time here  On the TwoNav Web site

    You can also use Garmin /bryton compatible mounts sold by Amazon, as in this image the TwoNav quick lock delivered mounts on the bryton like a Russian doll...

     

    Or

     

    Or

    https://www.twonav.com/media/catalog/product/cache/22/image/300x/9df78eab33525d08d6e5fb8d27136e95/c/r/cradle_bike_aventura-trail_03_1.jpg

    On Handlebar or on the Garmin as above..

    I tried all the solutions from the position on the pivot, the handlebars, the stem, the advanced mounting solution (triathlon type) on a rigid support is from my point of view ideal.

    To facilitate the reading of the screen, the position in front of the hanger on a garmin support is ideal, the support sold at Amazon is in aluminum it does not vibrate.

    An other user

    1
    Azioni per commenti Permalink
  • Avatar
    Adam Comish

    Thank you. Your solution looks pretty clean. So if I understand correctly, I can use a Garmin or Bruton mount, but the TwoNav handlebar stem mount must be attached to it, 'piggy back' style. I was hoping  the 'male' part on the back of the Trail 2 unit would click into a Garmin 'female' mount, without the need for the TwoNav mount to be attached by rubber bands

    0
    Azioni per commenti Permalink
  • Avatar
    Thierry CHARLÈS

    Hello,

    No, the fingerprints of the quick locks are not the same. You only put the "elastic" (like the photo) to center it. Then use 4 small black clamps (3 mm) quick tightening, everything will be very rigid. You can put a little glue between the Bryton and Twonav supports which partially fit together. The final assembly is clean and rigid, I rode again this afternoon with this solution. 

    Best regards

    1
    Azioni per commenti Permalink

Accedi per aggiungere un commento.